Canadian Mac Forums at ehMac banner
1 - 4 of 4 Posts

· Registered
132 Posts
Discussion Starter · #3 ·
Unfortunately, there weren't.
Previous owner replaced a CTO
Combo drive with his own SuperDrive,
but with too-small, regular screws.
Also forgot to replace the EMI shield,
and to set the rear PATA pins to
Cable Select. Am looking for the
Torx-10, regular height, standoffs.
Thanks for the suggestion. :)

· Premium Member
10,717 Posts
Do you have any Mac repair places in your area that just may have what you need?? Or just maybe, one of your local fastener places that just might have something or something close you could modify?

But then there's always good old good Canada grade Duct Tape or HD Velcro. ;)
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.